AYBmart insights
Better vacuum systems begin with better questions.
Focused notes on system safety, porous materials, compressed-air use, ejector staging, and tooling compliance.
Application notes
From component data to system behavior.
Each article connects a design choice to the measurements and validation steps that make it useful.
Designing Safer Pick-and-Place Systems
Use holding margin, sensing, zoning, fault response, and validation to make vacuum handling behavior visible and controlled.
Read article AYBmart insightWhen to Use Multi-Stage Ejectors
Choose staging from circuit volume, leakage, target vacuum, cycle time, air consumption, and the full performance curve.
Read article AYBmart insightHandling Porous Materials with Vacuum
Treat leakage as a design input when handling board, textile, foam, wood, perforated sheet, and other air-permeable workpieces.
Read article AYBmart insightReducing Compressed-Air Consumption in Vacuum Systems
Lower operating demand through leak control, right-sized generation, pressure discipline, air-saving control, and measured blow-off.
Read article AYBmart insightWhy Level Compensators Matter
Use controlled compliance to manage height variation, contact force, tooling tolerance, and load sharing at the suction interface.
Read articleHave an application question?
Bring the real constraints.
Share the workpiece, load, surface, cycle, utilities, and current challenge with AYBmart.